Publicité
Les langues disponibles
Les langues disponibles
Installation Options
In-Building Installation Option
1 .
Install the antenna to a window . These
instructions are for use with the weBoost
Magnet-Mount or Mini-Magnet Mount
Antenna . If you purchased a different
antenna separately, follow the instructions
included with that antenna .
• Select a window on the side of the building
where you get the strongest cell signal . You
can determine the strongest signal area by
walking around the building and checking
the bars on your mobile phone . You should
wait 30 seconds for new signal strength
to register . For a more accurate method
of determining signal strength, read the
instructions at http://www .weboost .com/us/
test-mode-instructions .
WAIT 30
SECONDS
• Clean a spot as high on the designated
window as possible with the alcohol prep pad .
Attach the suction cup bracket to the cleaned spot
on the inside of the window .
NOTE: Many newer energy efficient windows use
a metal coating that may decrease the strength of
a cellular signal, reducing the effectiveness of the
Drive 3G-Flex . If you have dual pane windows,
consider a weBoost signal boost product that
provides an option for mounting an antenna on an
outside wall or roof of a building .
Need help?
All manuals and user guides at all-guides.com
www.weboost.com
• With the bracket in place, attach the
magnet base of the antenna to the flat
surface of the bracket . The antenna must
be mounted vertically for the best signal .
2 .
Attach the antenna to the Drive 3G-Flex
signal booster . Connect the cable from the
antenna to the connector on the bottom
of the signal booster . Do NOT plug in the
power supply (step 4) until the antenna
cable is connected to the Drive 3G-Flex
signal booster .
3 .
Place the Drive 3G-Flex signal booster in
a convenient location close to your cellular
device . This can be on a desk, a tabletop,
a shelf, or the optional desktop mount (sold
separately) . The Drive 3G-Flex works best
when within three feet of your mobile device .
WORKS BEST
WHEN WITHIN
4 .
Connect the Drive 3G-Flex to a power
supply . Attach the AC power cord to the
mini-USB port on the bottom of the signal
booster . Plug the AC power cord into a
surge protected power strip .
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
3 FEET
5
Publicité
