Publicité
Les langues disponibles
Les langues disponibles
3. Hang the wall cabinet onto the GearTrack
Wall
Make sure the bracket is fully engaged in the wall slots as
■
shown. Tighten the pre-attached M6 x 16 hex socket head
screws fully into the bracket and make sure they go into the
wall slots.
NOTE: If installing the wall cabinet on GearTrack
a second channel must be installed 6"(15.24cm) below the
bottom of the supporting channel so the cabinet will hang
level.
NOTE: For installation of the Gladiator
please refer to the manual instructions included with the
Gladiator
GearTrack
®
®
4
ASSEMBLY INSTRUCTIONS
channel.
®
The GearTrack
channels should
be installed with
the spacing as
shown.
Tighten the M6 x 16 hex
socket head screws from the
inside of the wall cabinet
®
GearTrack
®
channels.
Install the 24"Flex 2-door Base
Cabinet
NOTE: Flex Brackets are sold individually and Gladiator
GearTrack
®
1. Install the brackets (P1) to the cabinet.
P6
6"
®
F3
channels,
channels,
®
P1: Bracket (2)
F2: M6 hex flange nuts (8)
Temporarily turn the base cabinet upside down as shown.
■
Attach the brackets to the back of the base cabinet as
■
shown with eight M6 round head square neck bolts (F5) and
eight M6 flange nuts (F3).
channels are sold separately.
X 2
X 8
F5
F5
P6
F1: M6 round head square
®
X 8
F3
Two brackets
required as
shown
bracket's
orientation
during assembly
neck bolts (8)
Publicité
