Monster Signature PRO 5100 PowerCenter Mode D'emploi page 31

This Monster PowerCenter features attachable/removeable rack handles.
To add the rack handles to this PowerCenter:
A) Remove the decorative plates on the front right and front left sides of the PowerCenter by using a screwdriver,
placing it on top of the screws, and turning it counterclockwise. There are two screws total, which will also be
used to fasten the rack handles to the PowerCenter.
B) Now, place a rack handle over the screw holes, place one screw in each of the two holes of the rack handles,
align the screw holes with the screws, and using a screwdriver, turn it clockwise until the rack handle rests
firmly against the PowerCenter and a tight connection is made. If a tight connection is not made, remove
the screw from the PowerCenter and repeat Step B.
C) Repeat this step with the second rack handle.
To remove the rack handles from this PowerCenter:
A) Remove the rack handles on the front right and front left sides of the PowerCenter by using a screwdriver,
placing it in each of the two holes in the rack handles, aligning the screw holes with the screws, and turning
it counterclockwise. There are two screws attaching each rack handle, four screws total, which will also be used
to fastening the decorative plates to the PowerCenter.
B) Now, place a decorative plate over the screw holes, place one screw in each of the two holes in the decorative
plates, align the screw holes with the screws, and using a screwdriver, turn it clockwise until the decorative plate
rests firmly against the PowerCenter and a tight connection is made. If a tight connection is not made,
remove the screw from the PowerCenter and repeat Step B.
C) Repeat this step with the second rack handle.
All manuals and user guides at all-guides.com
HOOK-UP GUIDE
25