Transport; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL TC-TS 315 U Instructions D'origine

•
Always push the cross stop or accessory
slide forward until the workpiece is cut all the
way through.
•
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
9.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
Anl_TC_TS_315_U_SPK9-1.indb 36 Anl_TC_TS_315_U_SPK9-1.indb 36
GB

9.4 Transport

Only ever transport the machine by lifting it by the
saw table. Never use the safety devices such as
the saw blade guard and stop rails for handling or
transporting purposes.
To transport with the slide (special accessory)
fi tted, the locking screw (117) must be secured so
that it stays in one position and cannot slip.
9.5 Additional notes on maintenance
Check the following each time before using
•
that the On/Off switch can be reliably swit-
ched off.
•
the braking time after switching off (<10 se-
conds)
If the On/Off switch is defective or the braking
time exceeds 10 seconds, do not use the machi-
ne any more and contact the customer services
team.
Always ensure that you place the machine on a
fi rm surface during transport, assembly, disas-
sembly, disabling and scrapping, to make sure
that it cannot topple over, fall over or move in an
uncontrolled manner.

10. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
11. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
!
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 36 -
23.03.2020 09:16:58 23.03.2020 09:16:58