Bosch GOF Professional 900 CE Notice Originale page 17

OBJ_BUCH-203-004.book Page 16 Wednesday, November 23, 2011 9:50 AM
16 | English
Intended Use
The machine is intended for routing grooves, edges, profiles
and elongated holes as well as for copy routing in wood, plas-
tic and light building materials, while resting firmly on the
workpiece.
With reduced speed and with appropriate routing bits, non-
ferrous alloys can also be machined.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Right handle (insulated gripping surface)
2 Lock-on button for On/Off switch
3 Thumbwheel for speed preselection
4 Spindle lock lever
5 Wing bolt for guide rods of parallel guide (2x)*
6 Chip shield
7 Router bit*
8 Seat for parallel guide rods
9 Guide plate
10 Step buffer
11 Adjusting screws for step buffer
12 Base plate
13 Dust boot
14 Wing bolt for depth stop adjustment
15 Depth stop
16 Slide with index mark
17 Left handle (insulated gripping surface)
18 Scale for depth-of-cut
19 Scale for depth-of-cut fine adjustment
20 Adjustment knob for depth-of-cut fine adjustment
21 Mark for zeroing
22 Release lever
23 Tightening nut with collet
Technical Data
Plunge router
Article number
Rated power input
No-load speed
Speed preselection
Constant electronic control
Connection for dust extraction
Tool holder
Plunge depth
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
1 619 929 J79 | (23.11.11)
24 On/Off switch
25 Open-end spanner, size 24 mm*
26 Extraction hose (Ø 35 mm)*
27 Extraction adapter*
28 Knurled screw for extraction adapter (2x)*
29 Parallel guide*
30 Guide rod for parallel guide (2x)*
31 Wing bolt for fine adjustment of parallel guide (2x)*
32 Wing bolt for coarse adjustment of
parallel guide (2x)*
33 Fine-adjustment knob for parallel guide*
34 Adjustable edge guide for parallel guide *
35 Extraction adapter for parallel guide*
36 Router compass/guide-rail adapter*
37 Router compass handle*
38 Wing bolt for coarse adjustment of
router compass (2x)*
39 Wing bolt for fine adjustment of
router compass (1x)*
40 Fine-adjustment knob for router compass*
41 Centring screw for compass stop *
42 Base spacer
(included in the "router compass" set)*
43 Guide rail*
44 SDS guide-bushing adapter
45 Fastening screw for guide bushing adapter (2x)
46 Release lever for guide bushing adapter
47 Guide bushing
48 Pan head screw for guide plate
49 Countersunk head screw for guide plate
50 Centring pin
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
GOF 900 CE
Professional
0 601 614 6..
W 900
-1
min 12000 – 24000
mm 6 – 8
inch
mm 50
kg 3.5
/II
GOF 1300 CE
Professional
0 601 613 6..
1300
12000 – 24000
6 – 12.7
¼ ¼ – ½
58
4.8
/II
Bosch Power Tools