Condensation inside and outside of the freezer.
If the climate is very humid, the formation of
condensation is normal.Opening the door or draw-
ers for prolonged periods of time can contribute to
the formation of condensation.
In any case, make sure that the doors are always
completely closed.
Ice or frost build up inside the freezer.
Did you leave the doors open for a long period of
time?
Do the doors close completely?
If the doors do not close completely, contact your
installer.
The doors are difficult to open.
The appliance is designed to ensure a fully hermetic
closure. When the door is closed, a vacuum condition
can occur: in this case it is necessary to wait a few
seconds until the pressure balances before opening
the door.
Appliance is cooling but lights and display are not
working.
Check to see if the appliance was accidently placed
into Sabbath Mode
The Ice Maker does not work.
Make sure that the Ice Maker is on (icon
To switch on the Ice Maker press the button.
Make sure that the appliance is connected to the
water supply.
The Ice Maker does not produce sufficient amounts
of ice.
On average, the Ice Maker produces approximately
10 cubes of ice every two and half hours.
The ice cubes freeze into one block.
If the ice is not used frequently, it is possible that
blocks of ice may form. It is recommended to remove
the block of ice cubes and then let the Ice Maker fill
the ice tray again.
The ice has an unusual flavour or colour.
When the Ice Maker is started for the first time, it
is recommended to empty the first full tray of ice
cubes.
If the freezer was switched off for more than one
month or if the cartridge was not changed for more
than six months, it could be necessary to replace
the filter cartridge.
Contact a plumber or a water treatment expert to
make sure that the problem is not due to the water
supply.
Ice Maker
).
Water Filter
Water System Purge
If the unit you purchased was used as a
showroom model it may be in a special en-
ergy-saving mode called Demo Mode where
the appliance appears to be operating (lights
work and false temperatures are displayed)
but no cooling actually takes place. If you sus-
pect your appliance is in Demo Mode please
contact your point of purchase for assistance
with disabling this feature.
EN
33