BGS technic 6036 Mode D'emploi page 4

USE
1. Set the eccentric shaft to the minimum stroke with a hexagon socket. Caution: The camshaft
must not run on the intermediate lever during removal and installation.
Required tool: Intermediate lever slide block (3)
2. Apply the tension lever for the intermediate lever return spring. Attention: Make sure that the
position is correct, the spring must rest in the lateral guides.
3. Tension the return spring with the compressor tool (1) and lock the tool.
4. Place the spring holder (2) in a bench vice.
5. Place the lever tool with the return spring in the spring holder and relax the return spring.
6. Repeat the above work for all others.
7. Dismantle the slide blocks.
8. Camshaft is ready to be removed.
NOTES
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed