Publicité
Les langues disponibles
Les langues disponibles
Installing the appliance
Bottom view
(A) SEALING STRIP
(C) SCREW
2. Carefully turn the hob back over and then
3. On the underneath of the hob, adjust the
(B) BRACKET
1. Remove the pan supports, the burner lid
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and
flame supervision devices are not
damaged in this operation.
Apply the sponge provided around
2.
the edge of the appliance.
Do not leave a gap in the sealing agent
3.
or overlap the thickness.
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
1. Place the bracket (B ) over the holes that
match the size of the screws.There are one
set of screw holes in each corner of the hob
(H).
Slightly tighten a screw (C) through the
bracket (B) so that the bracket is attached to
the hob, but so that you can still adjust the
position.
gently lower it into the aperture hole that you
have cut out.
brackets into a position that is suitable for
your worktop. Then fully tighten the screws
(C) to secure the hob into position.
17
V.3
Publicité
