Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
FAILURE TO SECURE THE GRILL MAY RESULT IN A RATTLING OR
HUMMING NOISE.
6.
Install 2 - 60 watt maximum, type A19 medium base incandescent bulbs (not included).
7.
Reinstall the glass lens in place by sliding the hole in the lens onto the rod from the grill
and securing in place with the lens knob removed in step 3 (Figure 14).
Rod
Glass Lens
Hole
Figure 14
8.
Restore power and test your installation.
Trouble
1. Fan does not operate when the switch is on.
2. Fan is operating, but air moves slower than normal.
3. Fan is operating louder than normal.
Installer:
Place of Purchase:
210572200 Rev. B 1-13
SECTION 7
Use and Care
CAUTION:
STARTING INSTALLATION.
1.
Grill
2.
CAUTION:
3.
Knob
4.
Troubleshooting Guide
Probable Cause
1a.
A fuse may be blown or a circuit tripped.
1b.
Connector plug from motor is not plugged in. 1b.
1c.
Wiring is not connected properly.
1d.
Motor has stopped operating.
2.
Obstruction in the exhaust ducting.
3a.
Motor is loose.
3b.
Fan blade is hitting housing of unit.
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE
Cleaning the Grill: Refer to instructions in Section 6 Completing the Installation, to
remove grill and glass light lens. Use a mild detergent, such as dishwashing liquid,
and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry all parts before reinstalling. Refer to instructions in Section 6 Completing
the Installation, to reinstall grill and glass light lens.
Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently vacuum the fan.
NEVER IMMERSE ELECTRICAL PARTS IN WATER.
ALLOW BULBS TO COOL BEFORE REPLACING.
Changing the Light Bulb: Disconnect power to the unit. Remove glass light lens from
grill by unscrewing knob at the top of lens (Figure 11). Replace light bulb(s) with 60 watt
maximum, type A19 medium base incandescent bulb(s).
Reinstall the glass lens in place by sliding the hole in the lens onto the rod from the grill
and securing in place with the lens knob (Figure 14).
Suggested Remedy
1a.
Replace fuse or reset circuit breaker.
Turn off power to unit. Remove Grill and plug motor into receptacle
in housing. Restore power to unit.
1c.
Turn off power to unit. Check that all wires are connected.
1d.
Replace motor.
2.
Check for any obstructions in the ducting. The most common are bird nests
in the roof cap or wall cap where the fan exhausts to the outside.
3a.
Turn off power to unit. Remove grill and check that all screws are fully
tightened. Restore power to unit.
3b.
Call your dealer for service.
Installation Date:
Model Number:
4 of 12
Publicité
