Flex FX1681 Manuel De L'utilisateur page 15

TURBO MODE
In turbo mode the tool delivers higher rotation
speed. The torque remains the same.
NOTE: When operating in turbo mode, the tool
depletes the battery pack charge faster.
NOTE: The turbo mode cannot be activated or
deactivated while the tool is in operation.
Press the turbo function button to activate
the turbo mode of the tool. The turbo function
indicator light will light up at the same time.
When you press the trigger switch the tool will
operate in turbo mode (Fig. 12).
To turn off the turbo mode, release the trigger
switch, and then press the turbo button. The
indicator light will turn off and the tool will
return to its "normal" mode.
LED LIGHT (FIG. 13)
Your tool is equipped with an LED light,
located on the base of the tool. This provides
additional light on the surface of the work piece
for operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
The LED light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
Fig. 12
Turbo Function
Indicator Light
Fig. 13
-15-
Turbo Function
Button
LED Light