Publicité
Les langues disponibles
Les langues disponibles
K
Storage
Keep your appliance on a level and safe place
out of reach of children.
Always remove the mains plug from the socket
if the appliance is not being used for a longer
time.
Wind up the power cable in the opening on
the bottom side of the device intended for this
purpose.
Do not wind the cable around the appliance.
NOTE
Caution, damage!
For storage, close the cover only
slightly, do not lock it so that the seals
do not deform thus impairing the
function of the appliance.
L
Accessories
Please use only the bag and rolls intended
exclusively for the vacuuming.
We recommend using original accessories from
Leifheit.
Freezer bags or cling film cannot be processed
using this appliance.
M
Disposal
If the appliance is discarded, it must be
rendered unusable (e.g. by cutting ff the power
cable and plug) and disposed of in accordance
with the current applicable legislations and
provisions in the country of use.
Your responsible council will provide you with
information.
Do not dispose of the appliance in
domestic waste.
Sort the packaging before disposal.
52
All manuals and user guides at all-guides.com
N
Troubleshooting
The vacuuming appliance does not function:
•
C heck the power cable for tight fit in the
socket.
•
E xamine the power cable for damage.
•
C heck if the socket works by connecting
another appliance.
•
C heck if the appliance is set to the correct
mode.
See operating instructions above.
•
M ake sure that the bag is positioned correctly
in the vacuum chamber.
•
C heck that the cover has engaged on both
sides of the housing.
•
T he appliance may be overheated due to
continuous operation and must cool down for
15 minutes.
T he air is not completely removed from
the bag:
•
I n order to ensure for a correct sealing, the
open end of the bag must be completely in the
area of the vacuum chamber.
•
C heck the sealing strips and the foam seals
under the cover for soiling and position. Make
sure that the foam seals on the cover and on
the base around the vacuum chamber do not
break or distort. Wipe clean and smooth them
again.
•
T he vacuum bag may have a leak. For testing,
seal the bag with a little air, immerse it in
water and apply pressure. Bubbles are an
indication that there is a leak. Seal the bag
again or use another one.
•
U se only bags recommended by the manufac-
turer.
•
L eaks may be along the seal that are caused
by folds, crumbs, grease of liquids. Open the
bag again, wipe out the top end of the bag and
smooth it along the sealing strip before re-
sealing.
Publicité
