aldes T.Flow Hygro+ Conseils De Montage page 5

This guide does not replace the complete installation instructions. For further information,
Any equipment failure due to non-observance of manufacturer instructions and failure to respect applicable standards and
regulations or lack of maintenance shall render the warranty null and void.
1. HANDLING
Correct handling
Screen must
face upwards
30° max
2. HEATER INSTALLATION
MIN.
350
T.Flow Hygro+
®
Kg
MIN.
350
Kg
MIN.
350
Kg
T.Flow Nano
®
WALL ON FRAME
MIN.
MIN.
350
MOUNTED
350
Kg
Kg
MIN.
350
Kg
If the heater is WALL-MOUNTED the installation must respect the
requirements of French standard NF DTU 60.1. Depending on the type of wall, it
may be necessary to install the heater on a tripod.
The water heater must be attached to the wall using screws and wall plugs suited to
the wall and the weight of the unit (in accordance with EN 60-335-1).
If the heater is installed ON A TRIPOD, it must always be fixed to the wall (at
least by the upper attachment bracket).
please refer to the complete installation instructions.
Incorrect handling
NEVER handle using
MIN.
350
the connection holes
Kg
MIN.
350
Kg
MIN.
350
Kg
NEVER handle with
the screen face down
The water heater must be installed on a
smooth, horizontal surface (+/- 1°).
If the surface is not level, the water heater must be
made level using its legs.
If this precaution is not taken,
condensation evacuation issues may occur.
Indicative weight
of filled water heater
• B100 T.Flow Nano:
176 kg
• B100 FAN-T.Flow Nano:
178 kg
EN
MUST NOT be
handled by one
person alone
5