JVC DLA-RS25 Manuel D'instructions page 35

* About "Color Management Adjustment"
1 Set the picture mode of the color management.
2 Select the color to be adjusted by color management.
just
Picture Ad
Color Management
>
Off Pause Off
Custom1
Red
Custom2 Yellow
Green
Custom3
Cyan
Blue
Magenta
All Reset
Hue
0
Saturation
0
Brightness
0
Back Check
Exit Operate
Before
BACK TEST
MENU Select
4 Select the "Hue", "Saturation" or "Brightness" using the
5 Use the
/ button to adjust.
Hue 7
●
You can switch between "Before" and "After" using the [TEST] button of the remote control.
6 To end
BACK BACK
●
After selecting "Cinema 1", "Cinema 2", or "Cinema 3" from "Picture Mode", and after adjusting "Advanced", adjustment of
brightness in each "Color Management" mode is not possible.
Picture Adjust > Lens Aperture
Lens Aperture
09
(Dark) -15 to 0 (Bright)
Reset
10
Reset the setting.
Input Signal > HDMI
HDMI
11
Configures HDMI input signal.
Input
Color Space
Control with HDMI
●
The setting is available only if the HDMI terminal is selected.
●
For some source devices,"Auto (input)" will not function properly. In such cases, please use Standard Mode or Enhanced
Mode.
●
Abbreviation
CEC: Consumer Electronics Control
Check
After
TEST
BACK
Auto
Standard
Enhanced
Auto
YCbCr(4:4:4)
YCbCr(4:2:2)
RGB
On
Off
3 Select color adjustment.
just
Picture Ad
Color Management
>
Off
Custom1
Custom2
Custom3
Exit
MENU
Select
/ button.
Save Color Management?
Yes No
Automatically configures the input signals.
Select this when the dynamic range of the input images is
16-235.
Select this when the dynamic range of the input images is
0-255.
Automatically configures the input signals.
Select this when the Y Cb Cr(4:4:4) video signals are
input.
Select this when the Y Cb Cr(4:2:2) video signals are
input.
Select this when the RGB video signals are input.
Enables CEC communications.
Disables CEC communications.
ENGLISH
Off
Pause
Red
Yellow
Green
Cyan
Blue
Magenta
All Reset
Hue
0
Saturation 0
Brightness
0
Back Check
Operate
Before
BACK TEST
OK
35