Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Remove all loose parts from the inside of the grill
and hopper. Lay a blanket or piece of cardboard
down to protect the grill.
Attach the Legs
With the help of another person flip the grill upside
down on the blanket or cardboard. The grill lid and
hopper lid will swing open when doing this so be
careful not to damage the lids. The grill may also
want to roll on its lid so one person should hold the
grill steady while the other person assembles the
bottom legs and wheels.
1. Lay the grill on its back.
2. Install each of the 4 legs as shown in Fig 1.
Make sure the legs with wheels are attached to
the right side of the grill with the wheels facing
out. Note: Front legs are marked with an F and
back legs are marked with a B.
3. Stand the grill upright
4. Tighten all hardware.
Attach Bottom Shelf
1. Install bottom shelf as shown in Fig. 2 by
installing hardware in each of the 4 corners.
2. Tighten hardware.
FIG. 2
M8 FLANGE NUT
M8 FLANGE NUT
M8 X 20 BOLT
M8 LOCK WASHER
FIG. 1
M8 X 60 BOLT
Attach Chimney and Chimney Cap
1. Install chimney to grill as shown in Fig 3. Make
sure to install the gasket between the grill and
the chimney.
2. Tighten all hardware.
3. Install M6 x 76 Bolt through chimney cap and
secure using Qty (1) M6 nut. Thread second nut
onto bolt leaving approximately 1.5" to the top
of the cap. Thread cap assembly down into the
chimney bracket until the lower nut hits the
bracket. See Fig 3.
4. The height of the chimney cap can be adjusted
for summer and winter. In the summer the gap
should be approximately 1-1/2". In the winter
M8 X 60 BOLT
the gap should be approximately ½".
5. Tighten all hardware.
M6 X 76 BOLT
M6 NUT
M6 X 15 SCREW
CHIMNEY GASKET
Install Handle
1. Install the handle as shown in figure 4.
2. Tighten all hardware.
HANDLE DEFLECTOR
M6 HANDLE SCREW
Install Shelf
(Optional-Do not install if installing sear box)
1. Install shelf as shown in Fig 5.
2. Tighten all hardware
Grease Bucket
1. Hang grease bucket from tube as shown in Fig 5.
M6 LOCK WASHER
M6 FLAT WASHER
M6 NUT
FIG. 3
FIG. 4
Publicité
