Publicité
Les langues disponibles
Les langues disponibles
Lighting Instructions
1. Press and hold he electronic igniter
buttton.
2. Turn the burner control to the high
position; press and hold in. When
the burner lights,release the
electronic igniter button.
3. Continue to depress the burner
controlknob for30 secondsand then
release. If the flame goes out,
repeat t he procedure.
4. Adjust the flame to the desired
height with the burner control
knob.
5. If the burner will not light with the
electronic igniter,holdalitlong match
or lit long butane lighter to the
ignition area of the burner and
continue with step 2.
6. To shut down the burner, turn the
burner control knob clockwise to
the off position. Then turn the gas
off at the source (propane cylinder
valve or natural gas supply valve).
WARNING
FOR YOUR SAFETY:
Keep your face and body away from
burner area when lighting.
Ensure burner controls are in the
off position. Slowly turn on the
gas supply valve.
WARNING
FOR YOUR SAFETY:
The propane cylinder is equipped
with an excess flow device.
Unless burners are turned off
prior to turning the cylinder on，
only small flames and low heat
will be achievable.
WARNING
FOR YOUR SAFETY:
If the burner does not light within
10 seconds， turn the valve off and
wait for 5 minutes for any gas to
dissipate before repeating the
procedure.
23
Publicité
