Publicité
Les langues disponibles
Les langues disponibles
6. Main menu
Antenna setting
Press the right arrow key to switch to the configuration. You can switch back with Exit.
LNB type
LNB voltage
22 KHz
Unicable setting
Toneburst
DiSEqC 1.0
DiSEqC 1.1
DiSEqC 1.2
Note:
You usually do not need to make any changes in the antenna settings. It is recommended that
only experienced users change the settings.
Common Interface
This menu shows all information about the CI module if a suitable module has been inserted. (see
page 22)
Signal information
This menu displays information about the currently selected satellite, transponder
signal strength and signal quality are displayed.
Import DVB-S programs (USB)
In these menu items, you can channel list load from USB. Note that if the existing list is not deleted,
it will be added to the end of the list.
DVB-S program export (USB)
In these menu items, you can copy your channel list to USB.
DVB-S program reset
In these menu items, you can delete your channel list to load a new from USB.
5V antenna feed
For active DVB-T2 antennas without their own power supply, you can activate the 5 Volt DC voltage
here to supply the antenna with the necessary supply voltage.
18
Change the LNB type here (default: 09750 / 10600).
Change the LNB voltage supply here (default: On).
Set the 22 KHz setting to on / off (default: Auto)
Select „On" if you want to operate the TV on a Unicable (EN50494).
Select the desired IF channel with the appropriate frequency.
If this does not match your system, you must change it manually.
Choose between None, Burst A, and Burst B
Choose between None, LNB 1 to LNB 4
Choose between None, LNB 1 to LNB 16
Select „On" if you need motor control.
ENGLISH
Publicité
