Panadero ONIX 3V Instructions D'utilisation Et D'entretien page 5

- The ease of access for the cleaning of the product, smoke outlet and chimney must be
considered. If you intend to install your stove near an inflammable wall, we advise
you to leave a minimum distance to facilitate cleaning.
- The stove should be installed on flooring with adequate support. If your current floor
does not comply with this criterion, it should be adapted with appropriate measures
(for example, a weight distribution plate).
FUEL
- Use only dry wood with a maximum moisture content of 20%. Wood with a moisture
content higher than 50 or 60% does not heat and combusts very badly, and creates
a lot of tar, releases excessive amounts of vapour and deposits excess sediments onto
the stove, glass and smoke outlet.
- The fire should be lit using special fire lighters, or paper and small pieces of wood.
Never try to light the fire using alcohol or similar products.
- Do not burn domestic rubbish, plastic materials or greasy products that can pollute
the environment and lead to risks of fire due to obstruction of the pipes.
- In TR R R IV V V ISIO O O N stoves, in order for the side windows to remain clean, the firewood to
be used must be very dry, with a humidity percentage of less than 1 1 1 2 2 2 % % % . . .
FUNCTION
- It is normal for smoke to appear during the first few uses of the stove, as certain
components of the heat-resistant paint burn whilst the pigment of the actual stove is
fixed. Therefore the room should be aired until the smoke disappears.
- The woodstove is not designed to function with the door open under any
circumstances.
- The stove is intended to function intermitently with intervals for recharging the fuel.
- For the lighting process of the stove it is recommended you use paper, fire lighters or
small sticks of wood. Once the fire starts to burn, add to it two logs of wood each
weighing 1 to 1.3 kg as a first initial charge. In this lighting process the air inlets of
the stove must be kept completely open. If necessary the drawer for removing ashes
can also be opened to begin with. Once the fire is more intense, close the drawer
completely (if open) and regulate the intensity of the fire by closing and opening the
air inlets.
- In order to achieve the stated nominal heat output of this stove a total quantity of
1.38 kg. of wood must be placed inside at intervals of 45min. The logs should be
positioned horizontally and separate from one another, to assure a correct
combustion. In any instance a charge of fuel must not be added to the
stove until the previous charge has been burnt, leaving only a basic fire bed which is
enough to light the next charge but no stronger.
5
Mod.
ONIX 3V/DIAMANT 3V
AMBAR 3V