Pattfield Ergo Tools PE-108 BS Traduction De La Notice Originale page 89

CONNECTING TO POWER SUPPLY
1 Plug into socket and press „RESET"
button, indicator switches on.
USING THE DRY GRINDING WHEEL
1 Hold the work piece to the grinding
wheel 14 at an adecuate angle.
FILLING / DRAINING WATER BATH
1 Insert the drain plug into the hole in
the lower part of the water bath 4. Use
only tap water, only fill below the drive
spindle 5. Wipe any spillage from the
machine.
REPLACING GRINDING WHEEL
1 Remove the wheel guard
ing the securing bolts 11.
2
Hold the grinding wheel
remove the locking nut.
REPLACING WET GRINDING WHEEL
1 Remove the water bath securing
screws 3 and remove the water bath 4.
2
Hold the wet grinding wheel
and remove the locking nut.
TEST
2 Press „T" button, indicator turns off.
Press „RESET" button again. Don't use
the grinder if test fails.
hand to ensure that they run freely.
USING THE WET GRINDING WHEEL
2 Hold the work piece to the wet grinding
wheel
2 After use place a suitable container
beneath the water bath 4, remove the
drain plug from the hole. Dispose of the
water in a reasonable way.
13 by remov- 3 Replace the grinding wheel and clean
the parts before reinstalling them ac-
cording to the picture.
14
firmly and
wheels to stop rotating.
3 Replace the grinding wheel and clean
the parts before reinstalling them ac-
cording to the picture.
1
firmly
wheels to stop rotating.
Caution! Before connecting to the
power supply, rotate the wheels by
1 at an adecuate angle.
Caution! Switch off and unplug the
grinder first. Wait for the grinding
Caution! Switch off and unplug the
grinder first. Wait for the grinding
EN 87