Publicité
Les langues disponibles
Les langues disponibles
WARNING
PLEASE MAKE SURE NOT TO DO DAMAGE ELECTRICAL WIRING OR OTHER NON-APPARENT EQUIPMENT WHEN
CUTTING. WHEN CONSTRUCTING THE CARPENTRY, ALWAYS FOLLOW ALL APPLICABLE BUILDING CODES AND
STANDARDS.
WARNING
: AT LEAST TWO (2) PERSONS ARE NECESSARY TO LIFT AND POSITION THEHOOD.
WARNING
: BE CAREFUL WHEN INSTALLING THE HOOD AS IT MAYHAVESHARP EDGES.
THAT YOU WEAR PROTECTIVEGLOVES.
CAUTION
: DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE HOOD AT THISSTAGE.
LOCATION PREPARATION
• It is recommended that the exhaust
• Before cutting, make sure that the separation distances for the fittings in the walls and/or roof are adequate.
• Before mounting the cabinet to the wall, cut the opening in the bottom of the cabinet beforehand.
1.
Disconnect the power source.
2.
Determine the method of discharge
3.
Choose a flat surface for
4.
Using two or more people, lift the hood over the
PREPARING THE CUT-OUT
1. Use a jigsaw or reciprocal saw to cut an opening in the bottom of the cabinet, inside the frame
NOTE
For frameless cupboards, a ¾" (1.9 cm) front and rear edge is required to form a frame in the bottom of
:
the cabinet.
A ¾" (1.9 cm) thick support rod (not included) may be required for certain
OPENING DIMENSIONS
Model CVI28-SS
A = Opening in the cupboard
Model CVI34-SS
system be
set up before the hood is installed.
to be
used:
discharge through the wall or roof.
the hood
assembly.
Place the protective material on
covered
3/4"
3/4"
this surface.
surface.
types of
3/4"
28"
''
34
WE RECOMMEND
.
cabinets.
16.5"
3/4"
''
16.5
Publicité
