Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the decorative panel from the rangehood.
2.
Cut a hole in the bottom of the cabinet, using the dimensions shown in the table above,
according to the model.
3.
Insert the hood in the cabinet and secure with the (4) mounting screws from the inner side
of the range hood. Make certain that the hood is secure before releasing. Note:
blocking
4.
Replace the decorative panel.
2.
Complete the closet preparation according to the instructions for the type of home evacuation. Determine the
location of the ventilation openings and cut out the openings in the cupboards, walls and / or soffits.
COMPLETING THE INSTALLATION
1. Re-install the filters.
2. Plug in the 3-tong plug in the properly grounded outlet that you was installed in the cupboard above
the cooking surface
3. Verify the operations of the hood and the lamps. See section "OPERATING THE HOOD". If the hood
does not operate, determine if a circuit breaker has opened or a home fuse
power source and inspect the
To get the most out of the new range hood, read the following section, "Operating the hood".
NOTE
:
might be necessary if there is no
wiring
connections.
frame to
secure the mounting screws.
Wood
is
blown. Disconnect the
Publicité
