All manuals and user guides at all-guides.com
LP 650 GUILLOTINE
REF. 93650
Mode d'emploi
Notch Cut
Make a lengthwise cut first to the desired
length on the floor plank as mentioned
above, then turn the plank 90°, and put
desired cutting point under the blade.
Unlock two screws on the blade holder and
pull out the blade as shown to above
mentioned desired cutting point, then pull
the handle down to complete a cut.
Changing the Blade
First loosen the two screws on the blade
holder and pull out the blade as shown.
Use provided Allan wrench to remove the
nine screws, then carefully move the
blade out of the small blade holder.
Note: the flat side of the blade should
face the working table.
Warning: Do not put your fingers against
the sharp edge of the blade at any time.
Transportation
Slide the lock pins to lock the cutting head
when the cutter is not use to keep the
blade in a close position for the safety as
shown on top illustration.
Pull out the carry handle while the lock
pins are released as shown on bottom
illustration.