Whispbar K327W Instructions De Montage page 5

EN
Fitting Kit
K327W
Remove masking tape and apply silicon
sealant around drilled holes.
Sit tracks on roof and line up tracks with
drilled holes.
Insert rivets through the tracks and into
drilled holes.
Fit pop rivet nozzle supplied with tracks to
your rivet gun.
Note: It is a standard thread to fit most rivet
guns. Use low pressure on air rivet guns.
Ensure that the front plugs are at the front
of the track and rear plugs at the rear.
Rivet tracks to roof.
Slide metal T-bolt into the track channel via
the entrance on the rear end plug. Two per
track.
5