FLORABEST FTP 400 C2 Traduction Du Mode D'emploi D'origine page 37

All manuals and user guides at all-guides.com
Switching on and off
1. Insert the plug in the socket. The pump
starts working immediately.
2. To switch off, withdraw the plug from
the socket. The pump stops.
If the water level is too low, the
float switch will automatically
switch off the pump.
Working
Supervise the appliance while it is
in operation in order to be immedi-
ately aware if the automatic cut-out
operates or the pump runs dry, to
limit any damage to a minimum.
In automatic mode, the float switch auto-
matically switches the pump on or off.
Adjusting the float switch:
The on/off switch point on the float switch
(
6) can be adjusted by changing the
position of the float switch in the float
switch grid ( 8).
In the case of stationary installation,
check regularly (no less then once
every three months) that the float
switch ( 6) is working.
Check the float switch (
- It must be positioned so that it
can lift and lower freely. The
switching point heights "On"
and "Off" must be easy to
reach.
Check this by placing the pump
into a vessel filled with water
and lift the float switch (6) care-
fully by hand and then lower it
- Ensure that the distance between
- During the adjustment of the float
The pump will run dry if too long a
float switch cable (
Maintenance and
Cleaning
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.
There is a risk of injury!
Pull out the power plug before eve-
ry maintenance operation. There is
a risk of electrocution or of injury
from moving parts.
General cleaning instructions
6):
• In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every use.
• In case of stationary installation, the
function of the float switch (
to be checked regularly (at the latest
every three months).
• With a water jet, remove fluff and
fibrous particles which are possibly
present in the pump casing (
again. In this case, you can see
whether the pump switches on
and off.
the float switch and the float switch
grid ( 8) is not too small.
switch (6), ensure that the float
switch does not contact the floor
before the pump switches off.
7) is chosen.
GB
6) is
3).
37