Evolite MaxBAR 210 IP65 Mode D'emploi page 17

o Troubleshooting
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
 The fixture does not work, no light
o Check the connection of power and main fuse.
o Measure the mains voltage on the main connector.
 Not responding to DMX controller
o DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
o If the DMX LED is on and no response to the channel, check the address settings
and DMX polarity.
o If you have intermittent DMX signal problems, check the pins on connectors or
on PCB of the fixture or the previous one.
o Try to use another DMX controller.
o Check if the DMX cables run near or run alongside to high voltage cables that
may cause damage or interference to DMX interface circuit.
 Some fixtures don't respond to the easy controller
o You may have a break in the DMX cabling.
o Check the LED for the response of the master/ slave mode signal.
 No response to the sound
o Make sure the fixture does not receive DMX signal.
o Check microphone to see if it is good by tapping the microphone.

Technical Specifications
Model
Voltage
Power consumption:
LED
Weight
Dimensions
MaxBAR 210 Manual Ver. 1.00
All manuals and user guides at all-guides.com
MaxBAR 210 IP65
110V- 250V / 50-60Hz
210W
42 pcs 5 Watts RGB 3 in 1
5.5 kg
535 x 153 x 182 mm
17
Page