Publicité
Les langues disponibles
Les langues disponibles
11. Drill two holes (diameter 8 mm/use the stencil) into the wall. Now screw the
screws and the dowels into the holes.
10 mm.
WARNING! Do not damage the wiring in the wall while drilling.
12. Position the inner chimney on the 2 screws and adjust it. Tighten the screws.
Insert the grease filters and connect the appliance to the mains
correct position of the hood from front and side perspective. Otherwise the
appliance will not work properly.
3
If the socket is covered by the chimney, you must plug in the appliance at an
earlier point in time.
30
3
. Check the
Publicité
