Publicité
Les langues disponibles
Les langues disponibles
WALL BRACKET MOUNTING AND MACHINE INSTALLATION
Identify mounting location where the cord can reach a wall outlet.
Installing into at least one stud is required.
Use stud finder to identify the mounting and make first mark in stud center
• From the first mark, measure 10" horizontally
• Mark second hole location
• Drill ½" hole at second mark
• Insert drywall anchor end into hole
• After metal anchor component is inserted,
pull back a little to ensure it as rotated and is
sitting flush against the back of the wall
• Zip drywall anchor, fastening it against hole
• Break off extra zip tabs
• Ensuring bracket is level, fasten
machine screw into anchor
6
After wall-side bracket is mounted, have a second person help lift the air
purifier and prepare to mount it to the wall bracket. Lift the machine up so
the machine-side bracket is above the wall-side bracket. Tilt the machine to
about 45 degrees and lower it until the machine-side bracket rests on the
wall-side bracket.
Carefully un-tilt the machine until it is resting vertically, supported by the
wall-side bracket, and the removal latch has engaged. The machine may
need to be gently slid left or right to ensure the latch is fully engaged. A
small click will be heard when the latch engages.
Run the power cord to the outlet to see how much extra cord will need
to be managed behind the machine. Attach the adhesive cable tie to
the back of the machine by removing the covering of the adhesive
pad and pressing firmly.
Ensure the removal latch lanyard is hanging down behind the machine
and not twisted or tangled.
Plug in the machine and the conversion and installation are complete!
Please reference your machine's original manual for operational
instructions.
Publicité
