Publicité
Les langues disponibles
Les langues disponibles
To adjust the skid shoes:
3. Use the 13 mm open end wrench to loosen the 4 hex nuts
(2 on each side). Move skid shoes to desired position
(Fig. 19).
13 mm wrench end
Skid shoe
Fig. 19
Hex nuts
4. Make certain the entire bottom surface of skid shoes
is against the ground to avoid uneven wear on the skid
shoes.
5. Retighten hex nuts securely.
Pre-Start
1. Charge batteries – See Charger Operation section on
page 10.
2. Check function of triggers – If triggers cannot engage or
disengage properly, adjust or repair before operation.
3. Check Skid Shoes – Check and adjust skid shoes.
Emergency Stop
Immediately release both triggers to stop unit in an emergency.
Wait for all rotating parts to stop before leaving operator's
position.
Operation
m
WARNING!
Failure to follow instructions could result
in personal injury and/or damage to snow blower. DO NOT
attempt to start your snow blower at this time. Read entire
operator manual first.
See page 13 for all controls and features.
m
WARNING!
Keep the area to be cleared free of stones,
toys or other foreign objects that the rotor blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
Starting the Machine
IMPORTANT! Make sure both triggers are released before
inserting the battery packs.
1. Open the battery compartment cover and slide two battery
packs down until they both click and lock into position
(Fig. 20). Close the cover.
Fig. 20
2. Flip up the safety switch, then squeeze the auger trigger
against the left-handle (Fig. 21). The auger will start
rotating and plowing snow.
Fig. 21
NOTE: Auger trigger should be engaged before drive trigger
when throwing snow.
3. Use the auger speed control lever to set a comfortable
plowing speed (Fig. 22).
15
Battery compartment cover
Battery packs
Flip up the safety
1
switch
2
Squeeze the
auger trigger
Publicité
