LENCO DIR-261 Mode D'emploi page 28

To cancel alarm completely, enter the alarm settings and set it OFF. The alarm icon will
disappear.
SYSTEM SETTINGS:
After Main menu setup is completed, enter system settings, the following page will appear.
1. In System settings menu, if Network is selected, the screen will appear as below.
When Network wizard is selected, the unit will scan the available wireless network.
After scanning, the wireless network name list will appear, select one and try to connect.
Refer to page 6.
When PBC Wlan setup is selected, the unit will scan the available wireless network.
Refer to page 6.
When View settings is selected, you can check the "Active connection",
"MAC address", "Wlan region", "DHCP", "SSID", "IP address", "Subnet mask", "Gateway
address", "Primary DNS" and "Secondary DNS".
When Wlan region is selected, refer to page 6.
2. In System settings menu, if Time/Date is selected, the screen will appear as below
28