Starting The Vacuum Cleaner - Termozeta Pocket 6000 Mode D'emploi

ASSEMBLING THE FLEXIBLE HOSE AND HANDGRIP
• Insert the end of the flexible tube inside the handgrip
• Block it by locking the pins in the ring nut inside the
slots in the handgrip of the flexible hose
VACUUM CLEANER ASSMEBLY
Carry out the following operations with the vacuum cleaner off and the plug
disconnected from the socket.
• Connect the flexible hose (16) to the vacuum cleaner:
Insert the nozzle (16a) in the flexible hose into the hose
inlet (5), until you hear a click.
• Connect the two extension tubes (18) and connect one
end of the handgrip in the flexible hose (17).
• Connect one of the accessories, most suited to your needs,
to the other end of the extension tube
• Dual use brush (14) (floors/ rugs and carpet): Use the
brush extracted for vacuuming smooth and hard surfaces
(e.g. floors), or retracted for rugs and carpets. To extract
or retract the brushes simply push the foot pedal (15) of
the brush.
• Brush nozzle accessory (19) It can be connected directly to the hand grip of the
flexible hose or to the extension tube (18). This accessory is used for hard to reach
areas (corners, crevices, radiators...) with or without the brush.

STARTING THE VACUUM CLEANER

• Make sure that the filter-bag (8) is positioned in place correctly.
• For further information, read the section on "Filter-bag
eplacement".
• Completely unwind the power cord and insert the plug in
the socket.
• Press the switch (3) to turn on the vacuum cleaner.
• The vacuum cleaner is equipped with a sensor (4) to signal
when the filter- bag is full.
When the sensor (4) changes colour, replace the filter-bag
follow the instructions in the "Filter- bag replacement" section.
PLEASE NOTE: When using the hook (13) to wind the cord, a
wheel is present and it should be positioned as shown in fig.1.
ENGLISH
Fig. 1