fadini Elpro 37 HP Manuel D'instructions page 15

Elpro 37 HP
GB
Accessory
Power connections
to Pulin 3 LEDs:
24 Vdc - 5 W output:
Traffic lights plug-in card (optional - Item No. 7282L):
The power supply of this card is independent from that of the control board:
230 V - 50 Hz with an output of 100 W at 230 V each lamp.
Logic of operation:
- GREEN light = driveway OPEN
- RED light = driveway CLOSED
- YELLOW light = it switches on before light changes from green to red.
Note: in pedestrians mode the traffic light is always RED.
Dip-switch - A
4 = ON Pre-flashing enabled: traffic lights red - yellow - green
4 = OFF Pre-flashing disabled: traffic lights red - green
Functioning with 2 lamps (red and green):
Dip-switch - A 4 = OFF
SINGLE - THREE PHASE ELECTRONIC CONTROL BOARD WITH
POWER CONTACTORS AND ELECTRONIC BRAKE FOR
SLIDING GATE AUTOMATIC SYSTEMS WITH OR WITHOUT LIMIT SWITCHES
Electrical connections
Terminals for the
3 28 27 26
connections of the LEDs
of the push buttons
Pulin 3
+ -
OUTPUT
36 37
24 Vdc - 5 W max
63 64 65 66 60 61
Fuse 1 A
(Optional: traffic lights plug-in card
for 230 V lamps) Item 7282L
15
Red
Yellow
Green
RED
YELLOW
GREEN