Publicité
Les langues disponibles
Les langues disponibles
3.
With the fan assembly (2) positioned as shown in FIGURE C, angle the bottom to engage the side tabs (3) of the fan
assembly bracket with the notches (4) in the knockout brackets on both sides. Refer to FIGURE C and D.
2
4
3
FIGURE
C
2
FIGURE
D
4.
Push the top of the fan kit assembly to rotate into position. The screw tabs of the knockout brackets should be
positioned under the screw heads of the fan kit assembly as shown below in FIGURE E, detail M.
NOTICE: Be careful not to pinch fan wires.
2
PUSH
5.
Tighten both screws (3). (Refer to section view in FIGURE F).
2
PUSH
FIGURE
E
3
FIGURE
F
Publicité
