Publicité
Les langues disponibles
Les langues disponibles
8
The food is too warm.
Interior lighting does
not work.
Heavy build-up of
frost, possibly also on
the door seal.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
Changing the light bulb
Warning! If the light bulb is
damaged, DO NOT CHANG IT BY
THE USER!
Changing the light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning.It must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force.
Center for help.
Before changing the light bulb, switch off the
appliance and unplug it, or pull the fuse or
the circuit breaker.
Light bulb data: 220-240 V, max. 15 W.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing the
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Please look in the "initial Start Up"
section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the "installation
location" section.
Please look in the "changing the
Light Bulb "section.
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the warmed
door seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
See the "cleaning and care"
section.
To switch off the appliance, set the
temperature regulator to position "0".
Unplug the mains plug.
To change the light bulb, undo the screw.
Press the light bulb cover as shown and
slide it backwards.
Change the defective light bulb.
Refit the light bulb cover and the screw.
Put the refrigerator back into operation.
Bulb(inside)
Lampshade
Thermostat knob
Publicité
