LIMIT LIKO112 Manuel D'utilisation page 4

4
ventilation, follow the instructions relevant
to installation.
Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor,
condenser) to prevent the risk of a fire,
follow the instructions relevant to
installation.
The appliance must not be locate close to
radiators or cookers.
Make sure that the mains plug is
accessible after the installation of the
appliance.
Control panel
Starting up and temperature regulation
Insert the plug of the connection lead into
the plug socket with protective earth
c o n t a c t . W h e n t h e r e f r i g e r a t o r
compartment door is opened, the internal
lighting is swiched on.
The temperature selector knob is located
on the RH side of the refrigerator
compartment.
Setting "0" means:
Off
Clockwise rotate the knob to turn on the
appliance.
Setting "1" means:Highest temperature,
warmestsetting.Setting "7" (end-stop)
means:Lowest temperature,coldest
setting.
First use and Installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
Service
Any electrical work required to do the
servicing of the appliance should be
carried out by qualified electrician or
competent person.
This product must be serviced by an
authorized Service Center, and only
genuine spare parts must be used.
1)If the appliance is Frost Free.
2)If the appliance contains freezer compartment.
Important! Normally we advise you select
setting of 2 or 3 or 4, if you want the
temperature warmer or colder please turn
the knob to lower or higher setting
accordingly. When you turn the knob to
lower which can lead to more energy saving.
Otherwise, it would result high energy-
consuming.
Important! High ambient temperatures (e.g.
on hot summer days) and a cold setting
(position 6 to 7) may cause the compressor
to run continuously or even non-stop!
Reason: when the ambient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance
Installation Positioning
Warning! Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.