Dometic PERFECTVIEW CAM55W Instructions De Montage Et De Service page 17

CAM55/55W
If you want to screw on the camera with self-tapping screws
(fig. b, page 5)
A
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 4 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through
the construction (fig. c, page 5)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when they
are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using M6 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. d, page 5)
I
NOTE
If possible, use available openings – such as ventilation grilles – to feed
the connection cables through. If there are no existing openings, you
must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to
come out
➤ Drill a hole of Ø 16 mm near the camera.
EN
All manuals and user guides at all-guides.com
Mounting the camera
17