Dometic PERFECTVIEW CAM55W Instructions De Montage Et De Service page 15

CAM55/55W
8 Mounting the camera
8.1 Tools required
For installation and assembly you will require the following tools:
• Drill bit set (fig. 1 1, page 2)
• Drill (fig. 1 2, page 2)
• Screwdriver (fig. 1 3, page 2)
• Set of ring or open-ended spanners (fig. 1 4, page 2)
• Measuring ruler (fig. 1 5, page 2)
• Hammer (fig. 1 6, page 2)
• Centre punch (fig. 1 7, page 2)
To make and test the electrical connection, the following tools are required:
• Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)
• Insulating tape (fig. 1 11, page 2)
• Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
8.2 Mounting the camera
!
CAUTION!
Select a location for the camera and attach it so securely that it cannot
under any circumstances fall off and injure bystanders (e.g. by being
knocked off by branches brushing over the roof of the vehicle).
I
NOTE
If installing the camera alters the vehicle height or length specified in the
vehicle documents, your vehicle must be inspected by the appropriate
authorities.
Make sure that you are in possession of documents verifying that your
vehicle has passed this inspection.
EN
All manuals and user guides at all-guides.com
Mounting the camera
15