Changing The Contact Points; Fitting The Collar; Checking The Device Operates Correctly; Cautions For Use - Num'axes CANICALM PREMIUM Guide D'utilisation

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient
to have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short contact points fitted to the collar in the factory are
inadequate, remove and replace them with the long contact points supplied with the kit.
A moderate manual screwing is sufficient (do not use any key).

Fitting the collar

The strap should be adjusted so that the contact points come right into contact with the dog's skin in
order to ensure good barking detection.
- If the strap is too loose, the collar will not operate properly. Moreover, it might move around the
dog's neck and repeated rubbing of the contact points on the skin can cause irritation.
- If the strap is too tight, the dog will have difficulties in breathing.
Regularly check your dog's neck as repeated rubbing of the contact points on the dog's skin may cause
irritation. If this happens, remove the collar until all signs of skin irritation have disappeared.
Do not leave the collar more than 8 hours a day around your dog's neck and take the time to check
that there are no signs of irritation when your dog is not wearing it.

Checking the device operates correctly

- Before doing so, make sure that the collar is turned Off.
- Fix each wire of the neon test lamp under each contact points (unscrewing them lightly and the
retightening them so as to pinch the test lamp wires).
- Switch On the collar (turn the collar on mode 2, 3 or 4, thus you will be able to check the operation
of beep sounds and stimulations).
- Make slide a streaked object (ex: knife with teeth with sleeve isolated) on one of the electrodes
(change the detection sensitivity if necessary).
- The collar will emit beep sounds and the test lamp will light (on mode 1, the test lamp will not light).
IMPORTANT : after being activated 5 times in quick succession, the collar will automatically go into
safety mode for 15 seconds, before restarting itself normally.

Cautions for use

- The collar should be used on dogs only over 6 months old.
- Before using the collar, it is important to have your dog checked by your vet to ensure it is fit to wear
a bark limiter.
- The collar is waterproof.
- To avoid unintentional triggering, the dog should not wear any medal, metallic collar, or any other
kind of collar together with the bark limiter collar.
Gb - 15