Publicité
Les langues disponibles
Les langues disponibles
SPECIAL gAS REQUIREMENTS (gAS MODELS SOLD IN
MASSACHUSETTS)
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS:
Gas leaks may occur in your system, creating a dangerous situation.
WARNING
– Gas leaks may not be detected by smell alone.
– Gas suppliers recommend you purchase and install a UL-approved
gas detector. Gas detector should be installed in accordance with the
manufacturers instructions.
• Range must be installed by a qualified plumber or gas fitter by the State of
Massachusetts.
• A T-handle manual gas valve MUST be installed in the gas supply line to your
range.
• If a flexible gas connector is used to install your range, multiple flexible gas lines
must not be connected in series.
ELECTRICAL REQUIREMENTS
To reduce the risk of fire, electric shock, or personal injury:
WARNING
All ranges
•
Do not use an extension cord or adapter plug with this range.
•
This range must be properly grounded.
•
Check with a qualified electrician if you are in doubt as to whether your range
is properly grounded.
•
Do not modify the plug provided with your range—if it doesn¡¯t fit the outlet,
have a proper outlet installed by a qualified electrician.
•
All wiring and grounding must be done in accordance with local codes or, in
the absence of local codes, with the National Electrical Code, ANSI/NFPA No.
70 – Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1
– Latest Revisions and local codes and ordinances.
•
Wiring diagram is located on the back of the range. (Inside of the cover back
wire)
•
This range is equipped with an electronic ignition system that will not operate
if plugged into an outlet that is not properly polarized.
installation requirements _25
Publicité
