Operation
Please use as much cable as
needed. Leave the remaining
cable out of the pool.
Please allow your robotic pool
cleaner to absorb water for
approx. 20 minutes.
3.6 m / 11.8 ft
bwt.com
Placement the Power Supply
(1) Place the power supply at least 3.6 meters / 11.8 feet from the
pool and at least 3.6 meters / 11.8 feet above the surface. CAUTION:
The power supply is not water resistant; it must not be exposed
to water or to direct sunlight.
(2) Press the plastic snap on the zip ties in order to release the
floating cable, use as much cable as needed into the water.
Before placing the cleaner unit in the water
You may
(1) Make sure there are no people in the pool. (2) Make sure that
turn on the
cleaner
the filters are clean. (3) Make sure the pool conditions are met; (see
when it
"Operating Conditions" ).
reaches the
floor.
Placing cleaner in the water
(1) Unroll the floating cable. It is recommended to extend a length
of cable that is equal to the pool diagonal size plus an additional
two meters. Smooth out coils or twists in the cable. Roll extra cable
outside the pool near the power and control unit. (2) Place the
cleaner unit in the pool. (3) Let it sink to the bottom of the pool. Do
12 cm / 4.7 inch
above ground
not start operation before the robotic cleaner is settled on the pool
floor. (4) Connect the floating cable to the socket located on the
power and control unit.
CAUTION: Operating the cleaner out of water causes
immediate severe damage and results in loss of warranty.
P400 / P410 / P500 LITE Robotic Pool Cleaner
3