Publicité
Les langues disponibles
Les langues disponibles
LOCATION
A) This room air conditioner is designed to fit
easily into a single or double hung window.
However, since window designs vary, it may be
necessary to make some modifications for safe,
proper installation.
B) Make sure window and frame are structurally
sound and free from dry and rotted wood.
C) For maximum efficiency, install the air
conditioner on a side of the house or building
which favours more shade than sunlight. If the unit
is in direct sunlight, it is advisable to provide an
awning over the unit.
D) Provide sufficient clearance around the cabinet
to allow for ample air circulation through the unit
(See Fig. 2). The rear of the unit should be
outdoors and not in a garage nor inside a building.
Keep unit as far away as possible from
obstacles/obstructions and at least 30" above
the floor or ground. Curtains and other objects
within a room should be prevented from
blocking the air flow.
E) Be certain the proper electrical outlet is
within reach of the installation. Use only a
single outlet circuit rated at 15 amps. All wiring
should be in accordance with local and
national electrical codes.
INSTALLATION INSTRUCTIONS
1) Assembly of the Upper Channel to
Cabinet.
• "L" Shaped Top Channel: Install the "L" shaped
channel to the top of the cabinet as shown in
Fig. 3, using four (4) 3/8" screws.
2) Assembly of the Side Curtains to Cabinet.
• Extend the shutter from the shutter frame and
slide it into the shutter tabs on the side channel
of the air conditioner, as shown in Fig. 4.
• Slide the shutters into the top ("L" Shaped) and
bottom ("U" Shaped) channels. The shutters are
identified (on frame) as left and right.
INSTALLATION
F) DO NOT install unit where leakage of
combustible gas is suspected. Your air
conditioner may fail to operate in air containing
oils (including machine oils), sulfide gas, near
hot springs, etc.
20"
Min
Side
Obstruction
Fig. 2
Fig. 3
5
30"
Min
Ground
3/8" screws
"U" shaped Channel
(Factory Installed)
Shutter tabs
Shutter
Shutter frame
Awning
12" Min
20"
Min
Fence,
wall, or
other
obstacle
"L" shaped
mounting bracket
Fig. 4
Publicité
