Transportation requirements
The appliance is fitted with wheels to make it
easier to move around. It can be tilted, if
necessary, in order to make transportation
easier. You should not turn the appliance back
on again for a minimum period of one hour
after performing this procedure.
Before tilting it, empty the condensed water
from the internal tank by extracting the
water drainage pipe from its housing and
removing the plug, Fig. 24. Place a
receptacle (or the appliance's removable
tank) at the end of the water drainage pipe
to collect the condensed water or lead the
pipe to the nearest drain. Do not forget to
replace the plug and reinsert the pipe in its
housing when the tank is empty.
Storage requirements
When the appliance is out of use for a long
period, set the expulsion tube to parking
position so that the appliance takes up as little
space as possible.
Technical service
Should your appliance fail to work properly and
all the instructions for use and installation
(especially the section headed
"
"
Requirements....
) have been carefully
observed, then remember that our Technical
Service Network is at your full disposal.
When contacting the Technical Service, quote
the model code (E-NR) and the appliance's
factory number (FD). This information can be
found on characteristics plate, Fig. 2.
Cleaning and Maintenance
Fig. 24
Technical service / Warranty
45
To do this, bend the tube towards the back
of the appliance and secure it with the
diffusion hook, Figs. 25 and 26.
Prior to use at change of season
Clean the air filter.
Clean the casing and the grilles if
necessary.
Warranty
The conditions of warranty depend on the
relevant Supplier in a particular country. Contact
the establishment where you purchased your
appliance for more information and quote the
appliance model and factory number. The receipt
of purchase for the appliance must be produced
prior to any work carried out under warranty.
Fig. 25
Fig. 26