Siemens PA0840M Mode D'emploi page 44

• Remove the basic filter from the appliance,
Fig. 20.
• Insert the double active filter + positioner in
the basic filter as shown on Fig. 22,
remembering that it must be housed on the
lower studs first.
clack!
2
• Install the assembly onto the appliance by
lining the lower studs up with the slots on the
front casing of the appliance and pressing the
top clip in until it clicks into position. The
assembly is fitted properly when it clicks into
position.
• Close the front flap.
Warning!
Fit only one set of filters onto the support
in order to ensure correct appliance
operation.
Note
The flaps on these models are fitted with
safety stops up to which point they can be
opened without risk of the front flap falling
and causing damage and/or injury. The
front flap can also be removed in order to
clean the appliance or change the filters
more easily, see Fig. 18. Afterwards, or
should for any reason the flap come out of
its original housing, proceed as follows to
fit it:
Cleaning and Maintenance
Fig. 21
Fig. 22
clack!
1
1° Lift the flap until it comes out of its
lower supports, (Fig. 23: a).
2° Position the plastic leg in the front
groove on the appliance (in T position)
and slide it down to the safety stop,
(Fig. 23: b).
3° fit the lower studs in the front stops on
the appliance making sure that the
plastic leg fitted in the previous step
does not come out of position,
(Fig. 23: c).
When finished, the user should make sure
that the flap is fitted properly and does not
fall when opened again. (The door opens
up to the safety stop). If not fitted properly,
repeat steps 1° and 2° again.
a
c
44
b
Fig. 23