LG WM3095CW Manuel Du Propriétaire page 23

Time and Status Display
Cycle Status Indicator
1
These LEDs illuminates when a cycle is selected
to indicate which stages runs. When a cycle is
running, the LED for the active stage blinks, and
the LEDs for the remaining stages remain steady.
Once a stage is complete, the LED turns off. If
a cycle is paused, the active stage LED stops
blinking.
Door Lock Indicator
2
The Door Lock indicator will light up once a cycle
has started. The indicator light will stay on until
the cycle is paused, stopped or has finished.
Control Lock Indicator
3
When the control lock function is activated, the
LED lights up. When the control lock function
is set, all controls are disabled except for the
Power button. Once the control lock function is
disabled, the LED turns off.
Estimated Time Remaining
4
When a cycle is selected, the default time for
that cycle is displayed. This time will change
as modifiers or options are selected. Once the
Start/Pause button is pressed, the washer will
measure the size of the load. The estimated
time may change once the load size has been
measured. If Delay Wash is set, the remaining
delay time counts down until the cycle begins.
NOTE
• The time shown is only an estimate. This
time is based on normal operating conditions.
Several external factors (load size, room
temperature, incoming water temperature, etc.)
can affect the actual time.
23
OPERATION