Philips Lumea SC1993 Mode D'emploi page 16

4 Place the device at a 90° angle on the skin so that the attachment and
the integrated safety system are in contact with your skin.
The integrated safety system prevents unintentional flashing without skin
contact..
5 Press the device firmly onto your skin to ensure proper skin contact. The
'ready to flash light' on the back of the device lights up green to indicate
that you can proceed with the treatment.
6 Press the flash button to release a flash. You should feel a warm
sensation because of the flash.
Note:The light produced by the device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
7 Place the device on the next area to be treated. After each flash, it takes
up to 3.5 seconds until the device is ready to flash again. You can release
a flash when the 'ready to flash' light lights up again.
8 To make sure that you have treated all areas, release the flashes close to
each other. Effective light only comes out of the light exit window,
therefore there should be some overlap. However, make sure you flash
the same area only once. Flashing the same area twice doesn't improve
the effectiveness of the treatment, but increases the risk of skin reactions.
9 When you have finished the treatment, press and hold the on/off button
for 2 seconds to switch off the device.
Treatment modes: Stamp & Flash and Slide & Flash
Philips Lumea has two treatment modes for more convenient use on
different body areas:
- The Stamp & Flash mode (available for SC1995, SC1993) is ideal to treat
small or curvy areas like knees and underarms. Simply press and
release the flash button to release a single flash.
- The Slide & Flash mode (only available for SC1995) offers convenient use
on larger areas like legs. Keep the flash button pressed while you slide
the device over your skin to release several flashes in a row.
17
English