Publicité
Les langues disponibles
Les langues disponibles
8.2 Hose coiler
The hose coiler is extra equipment and supplied only on request. The coiler is made of high-grade steel and
contains the following components:
-
hose drum
-
holder
-
swivel joint
-
crank handle
-
hose brake
Hose brake:
The hose brake is adjusted or completely clamped with the clamping pintle on the right side of the device.
We recommend to clamp the hose coiler during cleaning operation to prevent unwinding caused by
vibration.
Dismantling:
The hose coiler can be completely dismantled with the handle for car transportation to allow easy and
comfortable loading over a ramp.
Proceeding:
-
Uncouple connection hose from device to hose coiler at the swivel joint of the hose coiler.
-
Unfasten 4 fixing screws with PVC head on the back side of the device (do not unscrew completely).
-
Remove electric cable from the holder on the side of the handle.
-
Remove handle with hose coiler.
8.3 Special lances
Special lances are extra equipment and supplied on request. Lances can be changed with the KEW fast
coupling system on the torch.
The double lance allows stageless pressure adjustment with the handle.
The dirt blaster lance is suitable for very heavy contamination. The rotating pencil-jet generates a very
aggressive cleaning jet. Clean only suitable surfaces which are resistant to the strong jet.
The foam lance is used for foam output which is injected to the lance from the solution tank.
9 Injector with coupling
Models:
HZ07701
HZ07702
HZ07703
9.1 Use:
Injectors of type series HZ077 are designed for coupling between
-
device and hose or hose drum at the pressure side of the high-pressure
cleaner.
When using a stationary high-pressure line coupling is made between
tap and high-pressure hose (ill. right hand side: HZ07701/02).
The connection for chemicals with integrated non-return valve is
-
located at the injector followed by the suction hose with intake
strainer to aspirate the agent from an external container. Arrows
indicate the direction of flow.
Select the suitable injector depending on the high-pressure cleaner model to ensure the correct rate of
-
flow (see table „Models").
f. MBH1260 (jet size, screw-on: 2.1 mm)
f. MBH1800 (jet size, screw-on: 2.3 mm)
f. MBH2400 (jet size, screw-on: 1.9 mm incl. pressure relief valve)
page 8 of 10
Publicité
