Publicité
Les langues disponibles
Les langues disponibles
1
2
3
1. Buckle
2. Gate
3. Hip guard
4. Power head
5. Handles
6. Shaft
7. Lock-off switch
8. Trigger switch
9. Handlebar adjustment knob
10. Clamp spring (not shown)
11. Handle clamp
12. Harness mount
13. String trimmer guard
14. Line blade (not shown)
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Before use, read manual and labels of the power
head. Important assembly and use instructions
are provided in the power head manual. Connect
the attachment to the power head in accordance
with the power head manual.
Do not operate the tool without the correct guard
in place. The guard must be attached properly
during use. Operating the tool without the guard
could cause serious injury.
Always remove the battery pack before chang-
ing or removing accessories and adjusting the
handles.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
FUNCTIONAL DESCRIPTION
7
8
12
9
10
11
19
15. Spool release latch
16. Spool housing
17. Eyelet
18. Cutting line
6
4
Brush cutter
13
20
19. Brush cutter guard
20. Brush cutter blade
21. T30 hex wrench (not shown)
22. Head removal tool (not shown)
Do not use blades, brush cutting
WARNING
wheels, accessories, or attach-
ments other than those recommended by
MILWAUKEE. Serious injury or product damage
may occur.
Use both hands when operating the tool, according
to the attachment instructions. Maintain a firm
grip. Using one hand could cause loss of control
and result in serious injury.
Installing the String Trimmer Guard
Do not use the string
WARNING
trimmer guard with
the brush cutter blade. Operating
the tool without the correct guard
could cause serious injury.
The guard is shipped uninstalled and must be in-
stalled before use. Use caution to keep hands away
from the line blade.
1. Remove battery pack.
2. Line up the guard brack-
et with the holes in the
guard.
3. I n s e r t f o u r s c r e w s
through the guard and
into the bracket.
4. Tighten the screws se-
curely using the T30
hex wrench.
5
6
String trimmer
14
18
15
17
16
Publicité
