Domair PM40 Manuel D'utilisation page 29

3- Open the locking clips on the front
grille. Make sure that the safety screw
mounting holes line up and are at the
bottom of the grilles. Close the locking
clips and check that the 2 grilles are
tight and secure. Fix the small safety
screw onto the 2 grilles.
INSTALLING THE FOOT
1- Remove the "L" screw located in
the bottom of the foot's outer tube.
2- Assemble the foot's outer tube on
the base, referring to the
general drawing given above at the
beginning of the paragraph. Do not
INSTALLING THE HEAD ON THE FOOT
Unscrew the height adjustment knob
at the top of the outer tube. Pull up the
inner tube, adjust the height and
tighten the knob firmly.
Position the power unit on the inner
tube, aligning the holes into which the
mounting screw will be inserted. The
Operation
1. Before using this appliance, place it
on a stable, dry surface.
2. Insert the power plug into a wall
outlet.
3. Turn the On/Off button to select the
desired speed.
The air control speeds are as follows :
REV 1 – 09 09 19 Fabriqué en Chine
forget to position the ballast as shown
in the drawing.
3- Secure the base by firmly tightening
the "L" screw by hand.
head of the fixing screw has a square:
this must be embedded in the stand.
Also insert the small locking screw
and its knurled knob.
Secure by tightening the 2 knurled
knobs by hand.
1- Low Speed
2- Medium Speed
3- High Speed
4. Set the button to 0 to stop the
device
Page 29