Publicité
Les langues disponibles
Les langues disponibles
9
9A
9D
9E
9 SHOWER ARM & SPOUT INSTALLATION
Apply PTFE plumber's tape to both ends of Shower Arm (9A) according to manufacturer's
instructions. Insert the end of Shower Arm (9A) through the Shower Flange (9B).
Screw the end of Shower Arm (9A) into the pipe elbow inside the wall. Slide Shower
Flange (9B) tight to the wall.
Apply PTFE plumbers tape on both ends of Pipe Nipple (9C) according to manufacturer's
instructions. Screw Pipe Nipple (9C) onto the elbow inside the wall and tighten with
pipe wrench. The Pipe Nipple (9C) is to project 3
Protective Washer (9D) onto Pipe Nipple (9C). Screw Tub Spout (9E) onto Pipe Nipple
(9C) and tighten until Spout is properly positioned and flush to the finished wall.
9B
9C
7
3
/
" to 4"
8
(98 to 102 mm)
⅞
" to 4" from the finished wall. Insert
ENGLISH
10
10C
10D
10E
10 FLANGE INSTALLATION
Remove stem protectors (10A) from Valves (10B). Screw Threaded Nipples (10C) into
Valves (10B). Place Protective Washers (10D) onto Valves (10B). Screw Flanges (10E)
onto Threaded Nipples (10C) and hand tighten Flanges (10E) until snug against wall.
Reverse procedures to remove.
11
11E
11G
11D
11F
11F
11D
11 HANDLE INSTALLATION OR REMOVAL
These instructions cover two different types of handle installations Windsor™ (11A)
and Verve™ (11B).
Before proceeding, close all Valves. Attach Handles (11A or 11B) onto Stems (11C)
and secure with Screws (11D). Attach Buttons (11E) "H" on Left, (11F) "C" on Right,
and (11G), "Arrow in center..
Reverse procedures to remove.
4
10A
11A
11C
11B
10B
11C
Publicité
