Renkforce 1034065 Notice D'emploi page 20

7. Placement of the Clear Water Pump
• Attach a sufficiently strong, water-tight rope to the carry handle to lower the clear water pump, e.g. into
a well.
The clear water pump must never be held or attached by the mains cable or the float switch! This
may damage the mains cable; there is danger to life from electric shock! The clear water pump
also must not be attached via the hose.
Fasten the rope to a suitable holder.
Never put the clear water pump with the intake opening into dirt, sludge or leaf residue, e.g. in a
rain barrel, because this will clog the clear water pump. We recommend complying with a mini-
mum distance of 30 cm above ground.
• To connect the hose used by you to the clear water pump, you may use the enclosed connection piece
and the hose connection.
• There is a cable holder on the side of the carrying handle. It serves to fasten the cable to the float
switch.
The activation/deactivation water level will later result from the position in which the float switch cable
is attached.
Set the cable length that fits your site of use so that the float switch will switch the clear water pump on
and off as desired.
8. Commissioning
• After lowering the clear water pump into the well, etc. by a rope and fastening the rope accordingly,
plug the mains plug into a properly installed protective ground mains socket. This must be an IP44 mains
socket for operation in the outdoor area.
The mains plug must only be plugged into the mains socket when dry. There is danger to life from
electric shock otherwise!
• When the float switch is placed correctly, the clear water pump will switch on and start taking in water
and transporting it through the exit opening.
If no water is conveyed, there is still air in the clear water pump and the hose. You may be able to acce-
lerate the intake process if you fill water into the clear water pump or the hose, or if you move the clear
water pump slightly back and forth.
• The clear water pump switches off automatically if the float switch drops.
The clear water pump can also be operated manually by fastening the float switch to the clear
water pump by the cable holder accordingly or placing it higher.
The clear water pump pressure pump must not be operated unsupervised then, because the
clear water pump will not switch off if there is no water, which would damage the pump.
20