Publicité
Les langues disponibles
Les langues disponibles
adapter-cable.
2.
At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug
it in the DMX-output of the last unit.
3.
Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit
to the input of the next unit. The cable can not be branched or split to a 'Y' cable.
DMX512 is a very high-speed signal. Inadequate or damaged cables, solder joints or
corroded connectors can easily distort the signal and shut the system down.
4.
Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
6. Troubleshooting
There is no replacement part inside. Please contact your dealer for any
Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
The fixture does not work, no light
o Check the connection of power and main fuse.
o Measure the mains voltage on the main connector.
Not responding to DMX controller
o DMX LED should be on. If not, check DMX connectors, cables to see if link
o If the DMX LED is on and no response to the channel, check the address
o If you have intermittent DMX signal problems, check the pins on
o Try to use another DMX controller.
o Check if the DMX cables run near or run alongside to high voltage cables
Some fixtures don't respond to the easy controller
o You may have a break in the DMX cabling.
NEVER OPEN THE FIXTURE
properly.
settings and
connectors or on PCB of the fixture or the previous one.
that may cause damage or interference to DMX interface circuit.
problem.
DMX polarity.
19
Publicité
