Perel Tools HGG400PRO Notice D'emploi page 4

Bulk loading (from loader pump)
• Remove the gun outlet pipe [1] and connect a loader coupler (not incl.) that matches the loader
pump (not incl.).
• Operate the loader pump to load the grease gun. While doing this, the plunger handle [4] will
extend. When the groove in the rod becomes visible, the grease gun is full.
DO NOT pump more grease in the grease gun when the groove in the rod is
visible!
• Disconnect the grease gun from the loader pump and re-install the gun outlet pipe [1].
• Push the plunger handle [4] into the gun body as far as possible.
Suction loading
• Hold the gun body [3], plunger handle [4] pointing downwards.
• Unscrew the head assembly [5] by turning it counter clockwise with respect to the gun body [3].
• Place the open end of the gun body [3] in a grease container. Make sure no air can enter.
• Pull the plunger handle [4] out of the gun body [3] until the groove in the rod becomes visible.
Secure the handle by pushing the groove in the slot of the gun body.
• Screw the head assembly [5] back in place and release the plunger handle [4] from the slot.
• Push the plunger handle [4] into the gun body as far as possible.
7. Operation
• Connect the coupler of the grease gun to the equipment that needs to be greased. Refer to the
technical specifications below and verify that the grease gun and equipment are compatible.
• Use the pump handle [2] to release grease from the grease gun.
• When grease doesn't flow or flows irregularly air might be present inside the grease gun body.
Press on the air bleed valve [6] to remove it.
8. Technical specifications
capacity
max. pressure
dimensions
weight (empty)
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
00 (17/09/2008)
HGG400PRO
0.85 ~ 0.95g/stroke
69MPa (690 bar)
390 x 110 x 60mm
1.850g
4